Next step
1 Install the system board.
Installing the system board
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Unpack the new system board assembly.
CAUTION: Do not lift the system board by holding a memory module, processor, or other components.
CAUTION: Take care not to damage the system identication button while placing the system board into the chassis.
2 Holding the post, incline the system board, and lower the system board into the chassis.
3 Holding the system board holder, push the system board toward the back of the system until the release pin clicks into place.
Figure 107. Installing the system board
4 Using the Phillips #2 screwdriver secure the system board to the chassis with screws.
Next steps
1 Replace the following:
a Trusted Platform Module (TPM)
b Memory modules
c Processors and heat sink modules
d Internal USB key
158
Installing and removing system components
To Next Page
Loading...
