Dell EMC PowerEdge T640 - System Health and System ID Indicator Codes

System health and system ID indicator codes
The system health and system ID indicator is located on the front panel of your system.
Figure 7. System health and system ID indicators
Table 4. System health and system ID indicator codes
System health and system ID indicator code Condition
Solid blue Indicates that the system is turned on, system is healthy, and system
ID mode is not active. Press the system health and system ID button
to switch to system ID mode.
Blinking blue Indicates that the system ID mode is active. Press the system health
and system ID button to switch to system health mode.
Solid amber Indicates that the system is in fail-safe mode. If the problem persists,
see the Getting help section.
Blinking amber Indicates that the system is experiencing a fault. Check the System
Event Log for specic error messages. For information about the
event and error messages generated by the system rmware and
agents that monitor system components, see the Error Code Lookup
page at qrl.dell.com.
Dell EMC PowerEdge T640 overview 15