Dell EMC PowerEdge T640 - Removing the Processor from the Processor and Heat Sink Module

3 Set the PHM aside with the processor side facing up.
Figure 66. Removing the processor and heat sink module
Next step
1 Install the PHM.
Removing the processor from the processor and heat sink
module
Prerequisites
NOTE
: Only remove the processor from the processor and heat sink module if you are replacing the processor or heat sink. This
procedure is not required when replacing a system board.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
Installing and removing system components
119