Next step
1 Install the GPU power interposer board.
Installing the GPU power interposer board
Prerequisite
Follow the safety guidelines listed in Safety instructions.
Steps
1 Align the guide slots on the GPU power interposer board (PIB) with the guide pins on the chassis.
2 Slide the GPU PIB until the release pin locks into place and secures the PIB.
Figure 111. Installing the GPU power interposer board
Next steps
1 Install the system board.
2 Install the PSUs.
3 Follow the procedure listed in After working inside your system.
Removing the main power interposer board
Prerequisites
CAUTION
: To prevent damage to the main power interposer board (PIB), you must remove the power supply units (PSUs) from
the system before removing the PIBs.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the PSUs.
4 Remove the system board.
5 If installed, remove the GPU PIB.
Steps
1 Disconnect all the power cables from the main PIB.
2 Using the Phillips #2 screwdriver, remove the screws that secure the main PIB to the system.
3 Lift the main PIB out of the system.
162
Installing and removing system components
To Next Page
Loading...
