Figure 84. Installing optional IDSDM/vFlash module
Next steps
1 Install the MicroSD cards.
NOTE
: Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during
removal.
2 Follow the procedure listed in After working inside your system.
Backplane
Backplane connectors
Depending on the conguration, your system supports one of the following:
• 8 x 3.5 inch SAS/SATA backplane
• 18 x 3.5 inch SAS/SATA backplane
• 8 x 2.5 inch Dell PowerEdge Express Flash (NVMe) backplane
• 16 x 2.5 inch SAS/SATA backplane with the optional additional backplanes below:
– 8 x 2.5 inch NVMe backplane
– 16 x 2.5 inch SAS/SATA backplane (FlexBay)
• 32 x 2.5 inch SAS/SATA backplane
Installing and removing system components
139