Figure 34. Installing a 3.5 inch drive adapter into the 3.5 inch drive carrier
Next steps
1 Install the drive carrier.
2 If removed, install the front bezel.
Removing a 2.5 inch drive from a 3.5 inch drive adapter
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Remove the 3.5 inch drive adapter from the 3.5 inch drive carrier.
NOTE
: A 2.5 inch drive is installed in a 3.5 inch drive adapter, which is then installed in the 3.5 inch drive carrier.
Steps
1 Using a Phillips #2 screwdriver, remove the screws from the side of the 3.5 inch drive adapter.
2 Remove the 2.5 inch drive from the 3.5 inch drive adapter.
78
Installing and removing system components
To Next Page
Loading...
