Replacing the base cover
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
• Procedure
Procedure
1. Connect the battery cable to the system board.
2. Slide the tabs on the base cover into the slots on the computer base and snap the base cover into place.
3. Tighten the five captive screws that secure the base cover to the computer base.
14
To Next Page
Loading...
