Dell Alienware 13 R3 - Chapter 42: Replacing the Camera; Procedure; Post-Requisites

Replacing the camera
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1. Using the alignment posts, adhere the camera module to the display back-cover and antenna assembly.
2. Connect the camera cable to the camera module.
3. Adhere the tape that secures the camera cable to the camera module.
Post-requisites
1. Replace the
display bezel.
2. Replace the display assembly.
3. Replace the system board.
4. Replace the
battery.
5. Replace the coin-cell battery.
6. Replace the computer base.
7. Replace the rear-I/O cover.
8. Replace the
solid-state drive.
9. Replace the memory modules.
10.Replace the wireless card.
11. Replace the base cover.
61