Dell Alienware 13 R3 - Chapter 40: Replacing the Camera Cable; Procedure; Post-Requisites

Replacing the camera cable
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1. Route the camera cable through the routing guides on the display back-cover and antenna assembly.
2. Connect the camera cable to the camera module.
Post-requisites
1. Replace the
display hinges.
2. Replace the display panel.
3. Replace the display bezel.
4. Replace the display assembly.
5. Replace the
system board.
6. Replace the battery.
7. Replace the heat-sink assembly.
8. Replace the coin-cell battery.
9. Replace the
computer base.
10.Replace the rear-I/O cover.
11. Replace the memory modules.
12. Replace the solid-state drive.
13. Replace the wireless card.
14. Replace the
base cover.
59