Dell Alienware 13 R3 - Chapter 25: Removing the Speakers; Prerequisites; Procedure

Removing the speakers
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
• Prerequisites
• Procedure
Prerequisites
1. Remove the base cover.
2. Remove the
wireless card.
3. Remove the solid-state drive.
4. Remove the memory modules.
5. Remove the rear-I/O cover.
6. Remove the computer base.
7. Remove the coin-cell battery.
8. Remove the
battery.
9. Remove the heat-sink assembly.
10.Remove the system board.
Procedure
1. Remove the screw (M2x3) that secures the speaker to the palm-rest assembly.
2. Lift the left speaker off the palm-rest assembly.
3. Peel off the tape that secures the speaker cable to the palm-rest assembly.
4. Remove the speaker cable from the routing guides on the palm-rest assembly.
5. Lift the right speaker off the palm-rest assembly.
39