Dell Alienware 13 R3 - Chapter 27: Removing the Power-Adapter Port; Prerequisites; Procedure

Removing the power-adapter port
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
• Prerequisites
• Procedure
Prerequisites
1. Remove the base cover.
2. Remove the
wireless card.
3. Remove the memory modules.
4. Remove the solid-state drive.
5. Remove the rear-I/O cover.
6. Remove the computer base.
7. Remove the coin-cell battery.
8. Remove the
heat-sink assembly.
9. Remove the battery.
10.Remove the system board.
Procedure
1. Lift the power-adapter port bracket off the power-adapter port.
2. Lift the power-adapter port off the palm-rest assembly.
3. Remove the cable from the routing guides on the palm-rest assembly.
41