Removing the rear-I/O cover
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
• Prerequisites
• Procedure
Prerequisites
Remove the base cover.
Procedure
1. Remove the two screws (M2.5x6L) that secure the rear-I/O cover to the palm-rest assembly.
2. Using a plastic scribe, gently release the tabs that secure rear-I/O cover to the computer base.
3. Slide and remove the rear-I/O cover from the computer base.
21
To Next Page
Loading...
