Replacing the rear-I/O cover
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1. Slide the rear-I/O cover into the slots on the computer base and snap the rear-I/O cover into place.
2. Replace the two screws (M2.5x6L) that secure the rear-I/O cover to the palm-rest assembly.
Post-requisites
Replace the
base cover.
22
To Next Page
Loading...
