Replacing the display back-cover and antenna
assembly
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
Place the display back-cover and antenna assembly on a clean and flat surface.
Post-requisites
1. Replace the camera.
2. Replace the camera cable.
3. Replace the
display hinges.
4. Replace the display panel.
5. Replace the display bezel.
6. Replace the display assembly.
7. Replace the
system board.
8. Replace the battery.
9. Replace the heat-sink assembly.
10.Replace the coin-cell battery.
11. Replace the computer base.
12. Replace the
rear-I/O cover.
13. Replace the memory modules.
14. Replace the solid-state drive.
15.Replace the wireless card.
16.Replace the
base cover.
70
To Next Page
Loading...
