Dell Alienware 13 R3 - Chapter 28: Replacing the Power-Adapter Port; Procedure; Post-Requisites

Replacing the power-adapter port
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1. Slide the power-adapter port into the slot on the palm-rest assembly.
2. Place the power-adapter port bracket on the power-adapter port.
3. Route the power-adapter port cable through the routing guides on the palm-rest assembly.
Post-requisites
1. Replace the
system board.
2. Replace the battery.
3. Replace the heat-sink assembly.
4. Replace the
coin-cell battery.
5. Replace the computer base.
6. Replace the rear-I/O cover.
7. Replace the solid-state drive.
8. Replace the
memory modules.
9. Replace the wireless card.
10.Replace the base cover.
42