Replacing the light bar
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Align and slide the light bar into the slot on the chassis.
2 Replace the screw (M3x5) that secures the light bar to the chassis.
3 Connect the light bar cable to its connector on the chassis.
Post-requisites
Replace the right-side cover.
34
To Next Page
Loading...
