Dell D27M - Removing the Processor-Cooling Assembly; Prerequisites; Procedure

Removing the processor-cooling
assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Prerequisites
Remove the right-side cover.
Procedure
NOTE: Applicable only for computers with liquid cooling assembly
conguration.
1 Lay the computer on the left side and disconnect the fan cable from the system
board.
2 Disconnect the processor-cooling assembly cable from the system board.
3 In the reverse sequential order (as indicated on the processor-cooling assembly),
loosen the four captive screws that secure the processor-cooling assembly to
the system board.
82