Dell D27M - Replacing the VR Heat Sink; Procedure; Post-Requisites

Replacing the VR heat sink
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Align the three captive screws on the VR heat sink with the slots on the system
board.
2 Tighten the captive screws that secure the VR heat sink to the system board.
Post-requisites
Replace the right-side cover.
74