Dell D27M - Replacing the fan

Replacing the fan
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Align the slots on the system fan with the rubber grommets on chassis.
2 Route the rubber grommets through the slots on system fan and pull the rubber
grommets until the fan snaps into position.
3 Connect the system-fan cable to the system board.
4 Place the computer in an upright position.
Post-requisites
Replace the right-side cover.
67