Dell EMC VxFlex Ready Node - Page 172

When using the LDAP, the command should also include the LDAP domain it is using,
for example:
scli --mdm_ip 10.10.10.3,10.10.10.4 --login --username
JohnDoe@ldap.acme.com
The default user created during setup is the Super User, with the admin username.
Note: For detailed information on issuing CLI commands, see the CLI Reference
Guide .
Logging in
Command
login
Syntax
scli --login --username <NAME> [--password <PASSWORD>] [(--
ldap_authentication | --native_authentication)] [--
approve_certificate]
Actual command syntax is operating-system dependent. For more information, see
“CLI basics”.
Description/Notes
This command logs the specified user into the management system. Every user must
log in before performing CLI commands.
When a user is authenticated by the system, all commands performed will be done
with their respective role until a logout is performed, or until the session expires, by
reaching one of the following timeouts:
l
Maximum session length (default: 8 hours)
l
Session idle time (default: 10 minutes)
To log in to the AMS, from a local Linux AMS server, run:
/opt/emc/scaleio/ams/webapps/ROOT/resources/scli --login --
username admin --password <AMS_admin_password>
Example
/opt/emc/scaleio/ams/webapps/ROOT/resources/scli --login --
username admin --password Scaleio123
Output, similar to the following, is displayed:
Logged in. User role is Administrator. System ID is
0000000000000000
Security Management
172 Dell EMC VxFlex Ready Node AMS User Guide