Dell Force10 MXL User Manual

Deploying FCoE (FIP Snooping) on Dell Force 10 MXL
54
CLI configuration example: vPC on Cisco Nexus 5000 Series switch (secondary switch),
Figure 46.
without FCoE configuration (can be copied and pasted)
Key Items:
· On the secondary swith the role priority is changed to be a higher number, this setting
can be 1 to 65636 and default is 32667.
· Peer-keepalive destination address will be the address for the primary switch
· The rest of the settings should exactly match the primary switch so that they are
sharing the same PortChannels and vPC’s across the two switches.
feature vpc
feature lacp
vpc domain 1
role priority 2000
peer-keepalive destination 172.25.188.60
interface po4096
vpc peer-link
switchport mode trunk
interface po1
switchport mode trunk
vpc 1
interface po2
switchport mode trunk
vpc 2
interface ethernet 1/1-2
channel-group 1
interface ethernet 1/17-18
channel-group 2
interface ethernet 1/29-32
channel-group 4096 mode active

Dell Force10 MXL Specifications

General

Manageable	Yes
Product Series	Force10 MXL
Operating Temperature	0°C to 40°C (32°F to 104°F)
Layer Support	Layer 2, Layer 3
QoS Support	Yes
Power Supply	Dual, hot-swappable
Product Type	Switch
Jumbo Frame Support	Up to 9216 bytes
Management	CLI, SNMP, Web-based GUI
VLAN Support	Yes