Dell Force10 MXL

Deploying FCoE (FIP Snooping) on Dell Force 10 MXL
58
Step by step explanation of Dell Force10 MXL CLI example with multiple port (LAG) uplink to Cisco vPC
configuration.
o configure
o default vlan-id 20 – globally established VLAN 20 as the default VLAN
o interface TenGigabitEthernet 0/1
 no shutdown – configures the port as active.
 exit – exits interface configuration mode
o interface TenGigabitEthernet 0/49
 port-channel-protocol LACP – configures the port for LACP port-channel
 port-channel 5 mode active –sets the port-channel to 5 and sets mode to be active
 no shutdown – configures the port as active.
 exit – exit from interface configuration mode
o interface TenGigabitEthernet 0/50
 port-channel-protocol LACP – configures the port for LACP port-channel
 port-channel 5 mode active –sets the port-channel to 5 and sets mode to be active
 no shutdown – configures the port as active.
 exit – exit from interface configuration mode
o interface TenGigabitEthernet 0/51
 port-channel-protocol LACP – configures the port for LACP port-channel
 port-channel 5 mode active –sets the port-channel to 5 and sets mode to be active
 no shutdown – configures the port as active.
 exit – exit from interface configuration mode
o interface TenGigabitEthernet 0/52
 port-channel-protocol LACP – configures the port for LACP port-channel
 port-channel 5 mode active –sets the port-channel to 5 and sets mode to be active
 no shutdown – configures the port as active.
 exit – exit from interface configuration mode
o interface port-channel 5 – this moves into the port-channel 5 configuration
 portmode hybrid - configuring portmode hybrid will allow for the native VLAN untagged,
and a tagged VLAN to exist on the port together. This is similar to switchport mode trunk in
industry standard CLI.
 Switchport - this configures the port as a layer 2 port.
 no shutdown
 exit – exit the interface configuration