82
| Using the Operator Panel
7 Enter the new password, and then tap OK.
8 Re-enter the password, and then tap OK.
Disabling the Panel Lock
1 Press the (Information) button.
2 Tap the Tools tab Admin Settings.
3 Enter the password.
4 Tap until Secure Settings appears, and then tap Secure Settings.
5 Tap Panel Lock Panel Lock Control Disable OK.
6 Enter the current password, and then tap OK.
Setting the Power Saver Timer
The printer enters the power saver mode when the printer is not used for a certain
period of time. You can set the Power Saver Timer for the printer on the operator
panel.
1 Press the (Information) button.
2 Tap the Tools tab Admin Settings System Settings General
Power Saver Timer.
If Panel Lock Control is set to Enable, enter the password. See "Panel Lock."
3 Tap Sleep or Deep Sleep.
4 Tap – or +, or use the number pad to enter the desired value.
You can specify from 1 to 50 minutes for Sleep or 1 to 10 minutes for Deep Sleep.
5 Tap OK.
About the Concurrent Jobs Feature
This feature enables you to start a concurrent job while a fax job is running. This is done
by temporarily displaying the Home screen and switching to a different function that can
be run concurrently such as copy or scan.
1 While the printer is sending or receiving a fax, press the (Home) button.
2 Tap Copy.
Or
Tap Scan.
3 Change the copy or scan settings.
For details about the settings, see "Copying" or "Scanning."
4 Tap OK.
To Next Page
Loading...
