Identifier GUID-67274E98-E2F1-4B7B-A903-F38BA6B62028
Status Released
Replacing the system board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
NOTE: Your computer’s Service Tag is stored in the system board. You must
enter the Service Tag in the BIOS setup program after you replace the
system board.
NOTE: Replacing the system board removes any changes you have made to
the BIOS using the BIOS setup program. You must make the appropriate
changes again after you replace the system board.
Identifier GUID-E610713C-ED77-4B5B-B657-312963ECE003
Status Released
Procedure
NOTE: The system board is shipped with the coin-cell battery.
1 Align the screw holes on the system board with the screw holes on the middle
frame.
2 Replace the ve screws (M3x5) that secure the system board to the middle
frame.
102
To Next Page
Loading...
