Identifier GUID-FBA68EE4-1E13-4F28-9B84-362694B97060
Status Released
Replacing the power-button
board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Identifier GUID-BBCD2F9C-73C1-455D-B425-613C19121447
Status Released
Procedure
1 Connect the power-button board cable (0SDC1) to the power-button board and
route the cable through the routing guide on the middle frame.
2 Align the power-button board to the slot on the middle frame and place the
power-button board on the middle frame.
3 Align the screw holes on power-button board shield to the screw holes on middle
frame.
4 Replace the two screws (M2x3.5) that secures the power-button board shield to
middle frame.
Identifier GUID-7E8ED145-5E0A-485E-9E46-CFB1A1437B4E
Status Released
Post-requisites
1 Replace the inner frame.
2 Replace the stand.
43
To Next Page
Loading...
