Dell Inspiron 24 5000 - Side I;O-Board Service; Removing the Side I;O-Board; Prerequisites for Side I;O-Board Removal

Identifier GUID-7A647C13-3614-4248-8625-5BB2EBA6CAE1
Status Released
Removing the side I/O-board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Identifier GUID-B921E997-CD1E-4A7D-96D6-723B6E2D1F99
Status Released
Prerequisites
1 Remove the back cover.
2 Remove the stand.
3 Remove the inner frame.
4 Remove the system-board shield.
Identifier GUID-24C4BAED-5521-41AC-B66D-402B48A6789F
Status Released
Procedure
Before conducting the following removal procedure, disconnect and remove from the
respective routing the following cables:
• Antenna cables from the wireless-card.
• Speaker cable (SPEAKER) from the system board.
• Camera cable (WEBCAM) from the system board.
1 Disconnect the side I/O-board cable (MB-SUSBC) from the side I/O-board.
59