Steps
1. Insert the SIM eject tool (or paper clip) into the hole, next to the Nano-SIM card tray until the tray pops out.
2. Pull the tray out of the computer.
Installing the Nano-SIM card tray
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the Nano-SIM card tray and provides a visual representation of the removal procedure.
NOTE:
The Nano-SIM card slot is available in your computer depending on the region and configuration you ordered.
Removing and installing components 11
To Next Page
Loading...
