Steps
1. Loosen the three captive screws on the base cover.
2. Remove the six screws (M2x3.5) that secure the base cover to the palm-rest assembly.
3. Using a plastic scribe, pry the base cover starting from the top-left corner of the palm-rest assembly.
4. Lift the base cover off the palm-rest assembly.
Installing the base cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the base cover and provides a visual representation of the removal procedure.
Removing and installing components
13
To Next Page
Loading...
