Installing the fan (on computers shipped with discrete
graphics card)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of fan and provides a visual representation of the installation procedure.
Steps
1. Place and align the screw holes on the fan with the screw holes on the palm-rest assembly.
2. Replace the three screws (M2x3) that secure the fan to the palm-rest assembly.
3. Adhere the tapes (2) that secure the fan to the heat sink and the palm-rest assembly.
4. Adhere the tapes (3) that secure the I/O-board cable to the fan.
5. Connect the fan cable to the system board.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in after working inside your computer.
32
Removing and installing components
To Next Page
Loading...
