Steps
1. Remove the screw (M1.4x2.3) that secures the fan bracket to the palmrest.
2. Remove the fan bracket off the palmrest.
3. Peel the tapes that secure the antenna cables to the keyboard.
NOTE:
Applicable on computers shipped with WWAN card.
4. Remove the 28 screws (M1.2x1.5) that secure the keyboard to the palmrest.
5. Lift the keyboard off the palmrest.
Installing the keyboard
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the keyboard and provides a visual representation of the installation procedure.
Removing and installing components
57
To Next Page
Loading...
