Steps
1. Using the alignment post, slide and place the touchpad along with the bracket into the slot on the palm-rest assembly.
2. Adhere the touchpad cable from the touchpad.
3. Replace the four (M1.6x2) screws that secure the touchpad bracket to the palm-rest assembly.
4. Slide the touchpad cable into its connector on the touchpad and close the latch to secure the cable.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in after working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The following image indicates the location of display assembly and provides a visual representation of the removal procedure.
38
Removing and installing components
To Next Page
Loading...
