About this task
The following image indicates the location of speakers and provides a visual representation of the removal procedure.
Steps
1. Disconnect the speaker cable from the I/O board.
2. Peel the tapes that secure the speaker cable to the palm-rest assembly.
3. Note the routing of the speaker cable and remove the speaker cable from the routing guides on the palm-rest assembly.
NOTE:
Note the position of the rubber grommets before lifting the speakers.
4. Lift the speakers, along with the cable, off the palm-rest assembly.
Installing the speaker
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of speakers and provides a visual representation of the installation procedure.
Removing and installing components
35
To Next Page
Loading...
