Dell Inspiron 7490 P115G - Removing the Fan (on Computers Shipped with Integrated Graphics Card); Installing the Fan (on Computers Shipped with Integrated Graphics Card)

Removing the fan (on computers shipped with integrated
graphics card)
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The following image indicates the location of fan and provides a visual representation of the removal procedure.
Steps
1. Disconnect the fan cable from the I/O board.
2. Peel the tape that secures the fan to the heat sink and the palm-rest assembly.
3. Remove the three screws (M2x3) that secure the fan to the palm-rest assembly.
4. Slide and lift the fan slightly off the palm-rest assembly.
Installing the fan (on computers shipped with integrated
graphics card)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
33