Dell Inspiron 7490 P115G - Installing the M.2 2230 Solid-State Drive

4. Slide and remove the solid-state drive shield off the M.2 2230 solid-state drive on the system board.
NOTE: Applicable in computers shipped with WWAN card.
5. Slide and remove the M.2 2230 solid-state drive off the solid-state drive slot on the system board.
Installing the M.2 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the installation
procedure.
NOTE:
Computers shipped with WWAN card supports only M.2 2230 solid-state drive.
Steps
1. Align the notch on the M.2 2230 solid-state drive with the tab on the solid-state drive slot and slide the M.2 2230 solid-state drive into
the solid-state drive slot on the system board.
Removing and installing components
19