Steps
1. Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest assembly.
NOTE:
Push the rubber grommets into the slots if it pops out.
2. Route the speaker cable through the routing guides on the palm-rest assembly.
3. Adhere the tapes that secure the speaker cable to the palm-rest assembly.
4. Connect the speaker cable to the I/O board.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in after working inside your computer.
Touchpad
Removing the touchpad
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The following image indicates the location of touchpad and provides a visual representation of the removal procedure.
36
Removing and installing components
To Next Page
Loading...
