Steps
1. Open the latch and disconnect the touchpad cable from the touchpad.
2. Remove the four (M1.6x2) screws that secure the touchpad bracket to the palm-rest assembly.
3. Peel the touchpad cable from the touchpad.
4. Slide and lift the touchpad along with the bracket off the palm-rest assembly.
Installing the touchpad
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of touchpad and provides a visual representation of the installation procedure.
Removing and installing components
37
To Next Page
Loading...
