Steps
1. Adhere the coin-cell battery to the slot on the palm-rest assembly.
2. Connect the coin-cell battery cable to the system board.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in after working inside your computer.
WWAN card
Removing the WWAN card
Prerequisites
NOTE:
This procedure is only applicable for computers shipped with a WWAN configuration.
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The following image indicates the location of WWAN card and provides a visual representation of the removal procedure.
24
Removing and installing components
To Next Page
Loading...
