Steps
1. Using the alignment post, place the battery on the palm-rest assembly.
2. Connect the battery cable to the system board.
3. Replace the four screws (M2x2) that secure the battery to the palm-rest assembly.
Next steps
1. Install the base cover.
2. Follow the procedure in after working inside your computer.
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
The following image indicates the location of the coin-cell battery and provides a visual representation of the removal procedure.
22
Removing and installing components
To Next Page
Loading...
