4. Replace the four screws (M2x4.5) that secures the display hinges to the palm-rest assembly.
5. Slide the display cable into the connector to connect the display cable on to the connector on the system board.
6. Slide the touchscreen cable into the connector to connect the touchscreen cable on to the connector on the system board.
NOTE: Applicable only on computers with touchscreen configuration.
7. Align and place the display-cable bracket on the display cable.
8. Replace the three screws (M2x3.5) that secure the display-cable bracket to the system board.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in after working inside your computer.
I/O board
Removing the I/O board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the fan (discrete graphics card) or fan (integrated graphics card), whichever applicable.
About this task
The following image indicates the location of I/O board and provides a visual representation of the removal procedure.
42
Removing and installing components
To Next Page
Loading...
