Steps
1. Align the notch on the M.2 2280 solid-state drive/Intel Optane with the tab on the solid-state drive slot.
2. Slide the M.2 2280 solid-state drive/Intel Optane into the solid-state drive slot on the system board.
3. Align and replace the solid-state drive shield on the solid-state drive slot on the system board.
NOTE:
Solid-state drive shield is available only in computers that are shipped with Intel Optane or solid-state drive
that has a capacity of more than 512 GB.
4. Replace the screw (M2x3) that secures the solid-state drive shield to the system board.
5. Connect the battery cable to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in after working inside your computer.
Removing and installing components
17
To Next Page
Loading...
