b. base cover
c. microSD card
6. Follow the procedure in After working inside your computer.
Touchpad
Touchpad is part of the Palmrest assembly. These instructions are for reference only.
Removing the touchpad
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. microSD card
b. base cover
c. battery
3. Lift the actuator and disconnect the touchpad cable from the system board [1].
4. Remove the tape [2,3,4] securing the touchpad to the chassis.
5. Remove the three M2.0x3.0 screws [1] that secure the metal bracket to the touchpad on the computer.
38
Disassembly and reassembly
To Next Page
Loading...
