Dell Latitude 3310 - Display assembly; Removing the display assembly

5. Reconnect the battery cable to the connector on the system board.
6. Install the:
a. base cover
b. microSD card
7. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
NOTE: This process is for both touch and non-touch LCDs.
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. microSD card
b. base cover
c. battery
d. WLAN card
e. DC-in cable
3. Remove the tape [1] and unroute the antennae cable [2] near the fan case.
4. Remove the single screw that secures the EDP bracket [3] and remove it off the EDP connector on the system board [4].
5. Disconnect the EDP cable from the system board [5].
Disassembly and reassembly
57