Steps
1. Align and place the speakers in the slot on the chassis.
2. Route the speaker cables through the routing guide.
3. Connect the speaker cable to the connector.
4. Adhere the adhesive tapes to secure the speakers in place.
Next steps
1. Install the battery.
2. Install the base cover.
3. Install the microSD-card.
4. Follow the procedure in after working inside your computer.
WLAN card
Removing the WLAN card
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD-card.
3. Enter the service mode.
4. Remove the base cover.
About this task
The following images indicate the location of the WLAN card and provide a visual representation of the removal procedure.
Removing and installing components
23
To Next Page
Loading...
