Steps
1. Align and place the battery in the slot on the chassis.
2. Install the five (M2x3) screws to secure the battery in place.
3. Route the battery cable through the routing channel in the battery.
4. Connect the battery cable to the connector on the battery and adhere the adhesive tape.
5. Adhere the adhesive tapes to secure the battery in place.
Next steps
1. Install the base cover.
2. Exit the service mode.
3. Install the microSD-card.
4. Follow the procedure in After working on your computer.
System fan
Removing the left system fan
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD-card.
3. Remove the base cover.
4. Remove the battery.
About this task
The following image indicates the location of the left system fan and provides a visual representation of the removal procedure.
Removing and installing components
33
To Next Page
Loading...
