Installing the power adapter port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power adapter port and provides a visual representation of the installation
procedure.
Steps
1. Align and place the power adapter port on the chassis.
2. Route the power adapter port cable through the screw post.
CAUTION:
Carefully route the power adapter port cable through the screw post for installing the power
adapter port on the chassis.
Next steps
1. Install the system board.
NOTE: The system board can be installed with the heat sink attached.
2. Install the power button with fingerprint reader.
3. Install the heatsink assembly.
4. Install the input output board.
5. Install the display assembly.
6. Install the system fan.
7. Install the M.2 solid-state drive.
8. Install the speakers.
9. Install the base cover.
10. Exit the service mode.
11. Install the microSD-card.
12. Follow the procedure in after working inside your computer.
Removing and installing components
57
To Next Page
Loading...
