5. Remove the (M2x3) screw that secures the type-c bracket in place.
6. Lift and remove the system board from the system.
7. Lift and remove the type-c bracket from the system.
Installing the system board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the connectors on your system board.
Figure 2. System-board connectors
1.
Power button with fingerprint reader cable 2. Speaker cable
3. Display cable 4. Power cable
5. Backlit LED cable 6. Keyboard cable
7. Touchpad cable 8. Coin-cell battery cable
9. Input output board cable
The following images indicate the location of the system board and provide a visual representation of the installation procedure.
Removing and installing components
53
To Next Page
Loading...
