Steps
1. Align and place the system fan onto the palmrest assembly.
2. Install the two (M2x3) screws that secure the system fan in place.
3. Connect the system fan cable to the connector on the system board.
Next steps
1. Install the battery.
2. Install the base cover.
3. Install the microSD-card.
4. Follow the procedure in after working inside your computer.
Removing the right system fan
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD-card.
3. Remove the base cover.
4. Remove the battery.
About this task
The following image indicates the location of the right system fan and provides a visual representation of the removal procedure.
Removing and installing components
35
To Next Page
Loading...
