Steps
1. Align and place the battery in the slot on the chassis.
2. Install the three (M2x3) screws to secure the battery in place.
3. Route the battery cable through the routing channel in the battery.
4. Connect the battery cable to the connector on the battery and adhere the adhesive tape.
5. Adhere the adhesive tapes to secure the battery in place.
Next steps
1. Install the base cover.
2. Exit the service mode.
3. Install the microSD-card.
4. Follow the procedure in After working on your computer.
Removing the 4-cell battery
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD-card.
3. Enter the service mode.
4. Remove the base cover.
About this task
The following image indicates the location of the battery and provides a visual representation of the removal procedure.
Removing and installing components
31
To Next Page
Loading...
