About this task
The following image indicates the location of the coin-cell battery and provides a visual representation of the installation
procedure.
Steps
1. Align and place the coin-cell battery on the palmrest assembly.
2. Connect the coin-cell battery cable to the connector on the system board.
Next steps
1. Install the base cover.
2. Exit the service mode.
3. Install the microSD-card.
4. Follow the procedure in after working inside your computer.
Battery cable
Lithium-ion battery precautions
CAUTION:
● Exercise caution when handling Lithium-ion batteries.
● Discharge the battery completely before removing it. Disconnect the AC power adapter from the system and
operate the computer solely on battery power—the battery is fully discharged when the computer no longer
turns on when the power button is pressed.
● Do not crush, drop, mutilate, or penetrate the battery with foreign objects.
● Do not expose the battery to high temperatures, or disassemble battery packs and cells.
● Do not apply pressure to the surface of the battery.
● Do not bend the battery.
● Do not use tools of any kind to pry on or against the battery.
Removing and installing components 27
To Next Page
Loading...
