Installing the battery cable
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the battery cable and provides a visual representation of the installation procedure.
Steps
Connect the battery cable to the connector on the system board.
Next steps
1. Install the battery.
2. Install the base cover.
3. Exit the service mode.
4. Install the microSD-card.
5. Follow the procedure in After working on your computer.
Battery
Removing the 3-cell battery
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD-card.
Removing and installing components
29
To Next Page
Loading...
